Characterization of Biochar Derived from Crop Residues for Soil Amendment, Carbon Sequestration and Energy Use
Open accessThe DOI matches its Crossref record; 22 of the 22 references it cites were found in a registry or an index.
Abstract
The crop residues generated in agricultural fields are mostly considered a burden due to their disposal issues. This study attempts to effectively use pigeon pea stalk (PPS) for biochar production, a promising source as a soil amendment for carbon sequestration and alternative fuel source. PPS was pyrolyzed at different loads and reaction times to optimize the kiln temperature (350–400 °C and 450–500 °C) and changes in physicochemical properties, higher heating value (HHV) and yield were assessed. The results indicated that biochar yield, volatile matter, bulk density, O/C and H/C atomic ratios decreased, whereas fixed carbon, ash content and total porosity increased with increasing kiln temperature across all loads. Biochar produced at 450–500 °C (18 kg load kiln−1) had higher total carbon, nitrogen, phosphorous, recovered total carbon and total nitrogen, total potential carbon and CO2 reduction potential. Biochar produced at 350–400 °C had the maximum cation exchange capability (43.0 cmol kg−1). Biochar has estimated O/C and H/C atomic ratios of 0.07–0.15 and 0.35–0.50, respectively. Biochar exhibited good agronomic characteristics and fulfilled key quality criteria of H/C < 0.7 and O/C < 0.4 for soil carbon sequestration, as described by the European Biochar Certificate and the International Biochar Initiative. The estimated mean residence time and the mass fraction of carbon that would remain after 100 years were consistently greater than 1000 years and 80%, respectively. The biochar produced at 450–500 °C (at 18.0 kg kiln−1) from PPS had higher fixed carbon (65.3%), energy density (1.51), energetic retention efficiency (53%), fuel ratio (4.88), and HHV (25.01 MJ kg−1), as well as lower H/C and O/C ratios, implying that it is suitable for use as an alternative solid fuel.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Dynamic Molecular Structure of Plant Biomass-Derived Black Carbon (Biochar)
Keiluweit, M., Nico, P. S., Johnson, M. G., & Kleber, M. (2010) · Environmental Science & Technology · doi:10.1021/es9031419 · Cited by 3,230 · cited 5×
“Previous studies have demonstrated that the feedstock and production conditions have a significant influence on biochar yield [9,13,21,22], physicochemical characteristics [23–35]; stability and mean resident time (MRT) [9,25,36–43], total potential carbon (TPC) and CO2 reduction potential [44–46], and energy properti…”
BackgroundInfluentialBiochar for Environmental Management: Science, Technology and Implementation
(2015) · doi:10.4324/9780203762264 · Cited by 2,280
A review of biochar and its use and function in soil
Sohi, S. P., Krull, E., Lopez-Capel, E., & Bol, R. (2010) · Advances in Agronomy · doi:10.1016/s0065-2113(10)05002-9 · Cited by 2,240 · cited 3×
“microbial ecology and to neutralize the pH of acidic soils all while increasing the crop yield [3,6,7].”
BackgroundLibra, J. A., Ro, K. S., Kammann, C., Funke, A., Berge, N. D., Neubauer, Y., Titirici, M.-M., Fühner, C., Bens, O., Kern, J., et al. (2011) · Biofuels · doi:10.4155/bfs.10.81 · Cited by 1,756
The Art, Science, and Technology of Charcoal Production
Antal, M. J., & Grønli, M. (2003) · Industrial & Engineering Chemistry Research · doi:10.1021/ie0207919 · Cited by 1,623 · cited 3×
“ad) = (Mbiochar/Mstalk) × 100, where Mbiochar was the mass of biochar (kg) and Mstalk was the total mass of the raw stalk (kg) loaded into the kiln and Ybiochar,ad represents the air-dried yield of biochar (%) [55].”
BackgroundMethodResultReview of the stability of biochar in soils: predictability of O:C molar ratios
Spokas, K. A. (2010) · Carbon Management · doi:10.4155/cmt.10.32 · Cited by 1,160 · cited 1×
“A decrease in surface acidic functional groups with an increase in temperature range [63,64] might have contributed to the lower CEC values associated with the biochar in the present study.”
BackgroundEffects of temperature and particle size on bio-char yield from pyrolysis of agricultural residues
Demirbas, A. (2004) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2004.07.003 · Cited by 1,154 · cited 2×
“Significant changes in the amount of total C recovered with an increase in the production temperature range might have been related to the original feedstock concentrations of ash, lignin, cellulose, and hemicellulose and the pyrolysis temperature [60].”
BackgroundCharacterization of biochars to evaluate recalcitrance and agronomic performance
Enders, A., Hanley, K., Whitman, T., Joseph, S., & Lehmann, J. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.03.022 · Cited by 1,113
Ronsse, F., van Hecke, S., Dickinson, D., & Prins, W. (2013) · GCB Bioenergy · doi:10.1111/gcbb.12018 · Cited by 1,000
Characterisation and evaluation of biochars for their application as a soil amendment
Singh, B., Singh, B. P., & Cowie, A. L. (2010) · Soil Research · doi:10.1071/sr10058 · Cited by 991
Impact of torrefaction on the grindability and fuel characteristics of forest biomass
Phanphanich, M., & Mani, S. (2011) · Bioresource Technology · doi:10.1016/j.biortech.2010.08.028 · Cited by 892
Effect of cow manure biochar on maize productivity under sandy soil condition
Uzoma, K. C., Inoue, M., Andry, H., Fujimaki, H., Zahoor, A., & Nishihara, E. (2011) · Soil Use and Management · doi:10.1111/j.1475-2743.2011.00340.x · Cited by 832 · cited 2×
“We observed significantly higher biochar yield at the lower temperature range (350–400 ◦C), due to negligible condensation and volatilization of organic substances in the feedstock [21].”
BackgroundKookana, R. S., Sarmah, A. K., Van Zwieten, L., Krull, E., & Singh, B. (2011) · Advances in agronomy · doi:10.1016/b978-0-12-385538-1.00003-2 · Cited by 712
Comparison of biochar properties from biomass residues produced by slow pyrolysis at 500°C
Lee, Y., Park, J., Ryu, C., Gang, K. S., Yang, W., Park, Y.-K., Jung, J., & Hyun, S. (2013) · Bioresource Technology · doi:10.1016/j.biortech.2013.08.135 · Cited by 624
Biochar from water hyacinth (Eichornia crassipes) and its impact on soil biological activity
Masto, R. E., Kumar, S., Rout, T. K., Sarkar, P., George, J., & Ram, L. C. (2013) · CATENA · doi:10.1016/j.catena.2013.06.025 · Cited by 294 · cited 3×
“In recent years, the production of biochar via slow pyrolysis technology has piqued interest as a means of managing crop residues, and this conversion is a novel way to potentially add value to crop residues, with additional benefits such as reduced bulkiness, ease of milling, storage, handling, and low transportation…”
BackgroundLu, X., Pellechia, P. J., Flora, J. R. V., & Berge, N. D. (2013) · Bioresource Technology · doi:10.1016/j.biortech.2013.03.163 · Cited by 265
Kim, D., Lee, K., & Park, K. Y. (2016) · Journal of Industrial and Engineering Chemistry · doi:10.1016/j.jiec.2016.07.037 · Cited by 261
Chicken Manure Biochar as Liming and Nutrient Source for Acid Appalachian Soil
Hass, A., Gonzalez, J. M., Lima, I. M., Godwin, H. W., Halvorson, J. J., & Boyer, D. G. (2012) · Journal of Environmental Quality · doi:10.2134/jeq2011.0124 · Cited by 256 · cited 2×
“The presence of carbonates, inorganic alkalis and increased ash residue portion due to dihydroxylation of inorganic and organic matrices explains well the high pH value at 450–500 ◦C than at 350–400 ◦C [26].”
BackgroundInfluence of contrasting biochar types on five soils at increasing rates of application
Streubel, J. D., Collins, H. P., Garcia-Perez, M., Tarara, J., Granatstein, D., & Kruger, C. E. (2011) · Soil Science Society of America Journal · doi:10.2136/sssaj2010.0325 · Cited by 241 · cited 1×
“Recovery of total carbon (C) and nitrogen (N) in the biochar following slow pyrolysis was determined for each pyrolytic run based on the load (kg kiln−1), biochar yield (%), total C and N (%) content of PPS and biochar as follows [59],”
MethodCharacterisation, stability, and microbial effects of four biochars produced from crop residues
Purakayastha, T. J., Kumari, S., & Pathak, H. (2015) · Geoderma · doi:10.1016/j.geoderma.2014.11.009 · Cited by 196
Wijitkosum, S., & Jiwnok, P. (2019) · Applied Sciences · doi:10.3390/app9193980 · Cited by 167 · cited 1×
“These characteristics give biochar long-term chemical stability against microbial degradation [36], allowing it to persist in soil for hundreds of years [43].”
BackgroundAnupam, K., Sharma, A. K., Lal, P. S., Dutta, S., & Maity, S. (2016) · Energy · doi:10.1016/j.energy.2016.03.100 · Cited by 107
Cited by
Amalina, F., Razak, A. S. A., Krishnan, S., Sulaiman, H., Zularisam, A. W., & Nasrullah, M. (2022) · Journal of Hazardous Materials Advances · doi:10.1016/j.hazadv.2022.100134 · Cited by 349
RETRACTED: Biochar modulating soil biological health: A review
Bolan, S., Sharma, S., Mukherjee, S., Kumar, M., Rao, C. S., Nataraj, K. C., Singh, G., Vinu, A., Bhowmik, A., Sharma, H., et al. (2024) · Science of The Total Environment · doi:10.1016/j.scitotenv.2023.169585 · Cited by 209
RetractedAmalina, F., Syukor Abd Razak, A., Krishnan, S., Sulaiman, H., Zularisam, A. W., & Nasrullah, M. (2022) · Cleaner Materials · doi:10.1016/j.clema.2022.100137 · Cited by 166
Rizwan, M., Murtaza, G., Zulfiqar, F., Moosa, A., Iqbal, R., Ahmed, Z., Irshad, S., Khan, I., Li, T., Chen, J., et al. (2023) · Frontiers in Environmental Science · doi:10.3389/fenvs.2023.1277240 · Cited by 60
Metadata
- Authors
- Venkatesh, G., Gopinath, K. A., Reddy, K. S., Reddy, B. S., Prabhakar, M., Srinivasarao, C., Visha Kumari, V., & Singh, V. K.
- Venue
- Sustainability
- Publisher
- MDPI AG
- Published
- 2022-02-17
- Volume
- 14
- Issue
- 4
- Pages
- 2295
- ISSN
- 2071-1050 (ISSN-L)
- OpenAlex
- W4212983979
- Cited by
- 74
- References
- 22
- FWCI
- 4.25
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.