The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Frosting model for predicting macroscopic and local frost behaviors on a cold plate
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Deposition should be more homogeneous within the frost layer as shown by experimental observations (Lee and Ro, 2005) or the CFD results (Kim et al., 2015).”
From Frosting modeling on a cold flat plate: Comparison of the different assumptions and impacts on frost growth predictions (2016) · cites this paper as Kim et al., 2015
In the citing paper
“However, it is quite different than the one obtained using CFD by Kim et al. (2015) where the profile is quite constant within the frost layer and sharply decreasing close to the frost surface.”
From Frosting modeling on a cold flat plate: Comparison of the different assumptions and impacts on frost growth predictions (2016) · cites this paper as Kim et al. (2015)
In the citing paper
“Their simulations calculated the frost layer density and thickness separately starting from an initial frost layer.”
From Numerical Simulation of Frosting on Fin-and-Tube Heat Exchanger Surfaces (2017) · cites this paper as [23]
In the citing paper
“Kim et al. [23] assumed that the mass transfer at the frost surface occurs due to the water vapor concentration gradient and used the mass transfer rate per unit volume as a volumetric source or sink term to describe the mass transfer.”
From Numerical Simulation of Frosting on Fin-and-Tube Heat Exchanger Surfaces (2017) · cites this paper as [23]
In the citing paper
“Some frosting models have been coupled with multiphase flow models in CFD simulations [5,22,23].”
From Numerical Simulation of Frosting on Fin-and-Tube Heat Exchanger Surfaces (2017) · cites this paper as [23]
In the citing paper
“For water vapor density, its gradient inside the frost layer near the plate surface was significantly smaller than that near the frost surface [50,80,86,88,90,91].”
From Frosting mechanism and behaviors on surfaces with simple geometries: A state-of-the-art literature review (2022) · cites this paper as [86]
In the citing paper
“The frost density profile indicated that the frost density gradient inside the frost layer near the plate surface and frost surface were both significantly smaller than other regions within the frost layer [86,88].”
From Frosting mechanism and behaviors on surfaces with simple geometries: A state-of-the-art literature review (2022) · cites this paper as [86]
Citations
Cites
Numerical Heat Transfer and Fluid Flow
Patankar, S. V. (2018) · CRC Press eBooks · doi:10.1201/9781482234213 · Cited by 23,458
Numerical Heat Transfer and Fluid Flow
Hsu, C. (1981) · Nuclear Science and Engineering · doi:10.13182/nse81-a20112 · Cited by 15,188
A one-dimensional model for frost formation on a cold flat surface
Lee, K.-S., Kim, W.-S., & Lee, T.-H. (1997) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(97)00074-4 · Cited by 296
Self-citationA fundamental understanding of factors affecting frost nucleation
Na, B., & Webb, R. L. (2003) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(03)00194-7 · Cited by 225
Prediction of the frost formation on a cold flat surface
Lee, K.-S., Jhee, S., & Yang, D.-K. (2003) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(03)00195-9 · Cited by 190
Self-citationA mathematical model for predicting the densification and growth of frost on a flat plate
Tao, Y.-X., Besant, R. W., & Rezkallah, K. S. (1993) · International Journal of Heat and Mass Transfer · doi:10.1016/0017-9310(93)80011-i · Cited by 183
Modelling of frost growth and densification
Le Gall, R., Grillot, J. M., & Jallut, C. (1997) · International Journal of Heat and Mass Transfer · doi:10.1016/s0017-9310(96)00359-6 · Cited by 153
Frost growth and densification in laminar flow over flat surfaces
Kandula, M. (2011) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2011.02.056 · Cited by 141
Dimensionless correlations of frost properties on a cold plate
Yang, D.-K., & Lee, K.-S. (2004) · International Journal of Refrigeration · doi:10.1016/s0140-7007(03)00118-x · Cited by 134
Self-citationMass transfer on and within a frost layer
Na, B., & Webb, R. L. (2004) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2003.08.023 · Cited by 129
Modeling of frost growth and frost properties with airflow over a flat plate
Yun, R., Kim, Y., & Min, M.-K. (2002) · International Journal of Refrigeration · doi:10.1016/s0140-7007(01)00026-3 · Cited by 104
VOF MODELING AND ANALYSIS OF FILMWISE CONDENSATION BETWEEN VERTICAL PARALLEL PLATES
Liu, Z., Sunden, B. A., & Yuan, J. (2012) · Heat Transfer Research · doi:10.1615/heattransres.2012004376 · Cited by 100
Transient two-dimensional model of frost formation on a fin-and-tube heat exchanger
Lenic, K., Trp, A., & Frankovic, B. (2009) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2008.06.005 · Cited by 92
Modeling of frosting behavior on a cold plate
Yang, D.-K., & Lee, K.-S. (2005) · International Journal of Refrigeration · doi:10.1016/j.ijrefrig.2004.08.001 · Cited by 77
Self-citationPredictions of frost growth on a cold plate in atmospheric air
Cheng, C.-H., & Cheng, Y.-C. (2001) · International Communications in Heat and Mass Transfer · doi:10.1016/s0735-1933(01)00299-8 · Cited by 75
Frost formation on a cold surface under turbulent flow
Yang, D.-K., Lee, K.-S., & Cha, D.-J. (2006) · International Journal of Refrigeration · doi:10.1016/j.ijrefrig.2005.07.003 · Cited by 75
Self-citationFrost deposition in a parallel plate channel under laminar flow conditions
Lüer, A., & Beer, H. (2000) · International Journal of Thermal Sciences · doi:10.1016/s1290-0729(00)00193-8 · Cited by 64
Modeling of frost formation over parallel cold plates
Ismail, K. A. R., & Salinas, C. S. (1999) · International Journal of Refrigeration · doi:10.1016/s0140-7007(98)00069-3 · Cited by 61
Dimensionless correlations of frost properties on a cold cylinder surface
Kim, J.-S., Yang, D.-K., & Lee, K.-S. (2008) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2008.01.007 · Cited by 57
Self-citationFrost growth around a cylinder in a wet air stream
Ismail, K. A. R., Salinas, C., & Gonçalves, M. M. (1997) · International Journal of Refrigeration · doi:10.1016/s0140-7007(96)00065-5 · Cited by 42
An analytical study of frost nucleation and growth during the crystal growth period
Şahin, A. Z. (1995) · Heat and Mass Transfer · doi:10.1007/bf01463923 · Cited by 40
Heat and Mass Transfer to a Cryosurface in Free Convection
Barron, R. F., & Han, L. S. (1965) · Journal of Heat Transfer · doi:10.1115/1.3689144 · Cited by 37
(1994) · Cited by 28
Self-citationTao, Y.-X., & BESANT, R. W. (1993) · ASME Journal of Heat and Mass Transfer · doi:10.1115/1.2910665 · Cited by 19
Modeling of frost formation in a fibrous insulation slab and on an adjacent cold plate
Tao, Y.-X., BESANT, R. W., & REZKALLAH, K. S. (1991) · International Communications in Heat and Mass Transfer · doi:10.1016/0735-1933(91)90074-e · Cited by 12
Hermes, C. J. L., Piucco, R. O., Barbosa, J. R., Jr., & de Melo, C. M. R. (2009) · Experimental Thermal and Fluid Science · doi:10.1016/j.expthermflusci.2009.05.003 · Cited by 2
Research works printed but not linked: 1
- B.C. Na, Analysis of frost formation in an evaporator (Ph.D. thesis), The Pennsylvania State University, 2003.
Cited by
Sorted by citations
Review on the measurement and calculation of frost characteristics
Song, M., & Dang, C. (2018) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2018.03.094 · Cited by 212
Phase change mass transfer model for frost growth and densification
Wu, X., Ma, Q., Chu, F., & Hu, S. (2016) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2016.01.018 · Cited by 100
Frosting model based on phase change driving force
Wu, X.-M., Chu, F., & Ma, Q. (2017) · International Journal of Heat and Mass Transfer · doi:10.1016/j.ijheatmasstransfer.2017.03.081 · Cited by 94
Zhang, L., Song, M., Deng, S., Shen, J., & Dang, C. (2022) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2022.118984 · Cited by 83
Brèque, F., & Nemer, M. (2016) · International Journal of Refrigeration · doi:10.1016/j.ijrefrig.2016.06.010 · Cited by 70
Metadata
- Authors
- Kim, D., Kim, C., & Lee, K.-S.
- Affiliations
- Hanyang University (KR)
- Corresponding author
- Lee, Kwan-Soo
- Venue
- International Journal of Heat and Mass Transfer
- Publisher
- Elsevier BV
- Published
- 2015-03
- Volume
- 82
- Pages
- 135-142
- ISSN
- 0017-9310 (ISSN-L)
- OpenAlex
- W2067594704
- Cited by
- 103
- References
- 26
- Citations by year
- 2026: 7 · 2025: 15 · 2024: 8 · 2023: 10 · 2022: 14 · 2021: 11 · 2020: 6 · 2019: 5 · 2018: 14 · 2017: 6 · 2016: 6 · 2015: 1
- FWCI
- 6.39
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- International Journal of Heat and Mass Transfer (publishedVersion)
- The Royal Society of Chemistry’s Journals, Books and Databases (The Royal Society of Chemistry) (submittedVersion)
- Funders
- Ministry of Education, Science and Technology (2013R1A2A2A01067816)
- National Research Foundation of Korea
- Topics
- Physical Sciences › Engineering › Aerospace Engineering › Icing and De-icing Technologies
- Physical Sciences › Engineering › Mechanical Engineering › Refrigeration and Air Conditioning Technologies
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer and Optimization
- Keywords
- frost formation, frost growth, cold plate, frost thickness, frost density, relative humidity, inlet velocity, computational fluid dynamics
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
